Jump to content

yanni

LP Member
  • Posts

    25
  • Joined

  • Last visited

About yanni

  • Birthday 02/24/1964

Profile Information

  • Gender
    Male
  • Location
    1202 woodbine ave toronto
  1. yanni

    91 diablo

    Just installed by pass tubes ,car runs excellent,thanks for all the help from the other memebers
  2. yanni

    91 diablo

    Just finished removing the cats at work,i own a auto service garage ,the right side converter is rattling,outside cover is blue,does anybody have bypass pipes for sale. please let me know,anyways thanks for all the replies.
  3. yanni

    91 diablo

    You guys are great,i tried the key code reader ,no codes . This site is amazing for support to all lambo owners,i,m going to figure it out and let you know. Yanni
  4. yanni

    91 diablo

    both fans work fine,water temp does not even reach 100, hovers below,car will rev to 6000 when standing still,i did add almost a gallon of anti freeze ,the bleeders are seized,both exhaust manifolds at roughly the same temp,the hissing sound on the right side of engine which is the left side of car gets louder and softer,on a normal car this is a sign of a catalytic converter clogged up,do you know how a stock muffler works on my diablo,does the exhaust exit on the opposite side of the inlet pipe , battery is putting out 13.2 volts,i forgot to mention that when the car starts to bog down there is a lot of gas smelling from the back of the car.could be an air pocket in around the coolant sensors. From the time of purchase to having car physically with me there was no more than .5 of a kilometer from time of transport, this problem started when air filter housing was removed as well as the drivers side wheel well, and the car revede up to say 3000 rpm to check for hissing sound,thats when emission light went on then the stall,then I started engine, the light was on left bank emission ,then 30 seconds later the light went off. Any thoughts
  5. yanni

    91 diablo

    I,m in Toronto canada
  6. yanni

    91 diablo

    thanks for the respond,i do not know I can try to change filters fuel,some times engine temp climbs as well upon acceleration,did happen on test drive with previous owner.but car drove fine
  7. great site,just purchased my first diablo,when I was inspecting it I could hear a hissing sound on the drivers side right where the two into one pipe connector.The car drove fine on the initial test drive. After getting the car home,i ran the car without the air filter assembly attached on the drivers side ,and after a slight rev the left check light came on and kind of bogged and then engine stalled, I installed the air filter assembly the light went on after starting up right away,yhen the light went off.what I have noticed now is the tail pipe on the drivers side does not have the pressure that the tail pipe on the passenger side has,i suspect this car needs a converter.also the car boggs down around 4000 rpms. any thoughts. thamks
  8. great site,just purchased my first diablo,when I was inspecting it I could hear a hissing sound on the drivers side right where the two into one pipe connector.The car drove fine on the initial test drive. After getting the car home,i ran the car without the air filter assembly attached on the drivers side ,and after a slight rev the left check light came on and kind of bogged and then engine stalled, I installed the air filter assembly the light went on after starting up right away,yhen the light went off.what I have noticed now is the tail pipe on the drivers side does not have the pressure that the tail pipe on the passenger side has,i suspect this car needs a converter.also the car boggs down around 4000 rpms. any thoughts. thamks
  9. i own a service centre automotive,to date i have built two tube frame cars,which look like lambos,i don,t need help with welding farricating,i need chasisis prints ,demensions,
  10. i,m only needing to have a roller ,factory suspension,rack,.hubs ,after maeket coil overs.body i have.
  11. could you supply me with web address ,tried cannot find them,or i need location ,thanks. i need to know where the front suspension pick up points are for the control arms.
  12. Hi all ,new to this site,i have a tube frame bare,the problem is the front half was cut away and is missing forward from the top of the window frame,i,m looking to build a lambo race car,need help to find replacement ,or demensions to rebuild front half of this frame. The chassis is from a 1987 countach. yanni
×
×
  • Create New...