Hi everyone, i just bought my first 07 gallardo and now is time to replace the clutch. In my country there is no lamborghini dealer and now i found a mechanic who can replace the clutch, but as i can see from the manual after this i need to carry out the e-gear initialization. To do this my friend bring me the Lambo diagnostic computer with LaRa 7.0 installed but I don't know what to do. Does anyone know how to make E-gear initialization after clutch replacement ?
PLEASE HELP, i really need this...
Inside help files L140-Gallardo -LaraAS sistem.pdf and 04_E-gear_BasicSetting_ENG.pdf, i found few procedures:
1. For Clutch replacement: "4-Neutral Engagement -> 5-Hydraulic Circuit Discharge -> Removal of E-gear kit and transmission→clutch replacement→re-installation of transmission and E-gear kit -> 6 - Hydraulic Circuit Bleeding -> 5 - Hydraulic Circuit Discharge -> Oil level checkand top-up of oil in reservoir -> 1 - Clutch Kiss Point -> 2 - Grid Self Tuning -> 3 - Clutch Degradation Index reset"
2. For Replacement of E-gear kit: "4 - Neutral Engagement -> 5 - Hydraulic Circuit Discharge -> Replacement of E-gear kit -> 6 - Hydraulic Circuit Bleeding -> 5 - Hydraulic Circuit Discharge -> Oil level check and topup
of oil in reservoir -> 1 - Clutch Kiss Point -> 2 - Grid Self Tuning"
what procedure i should follow ?
Also i found the following scripts:
Bleading_Gallardo.dra (allows the clutch of e-gear vehicles to be bled)
E-gear_snap_new_Gallardo.dra (allows acquisition of the data in the e-gear control unit.)
Open_solenoid_Gallardo.dra (allows the e-gear system to be bled after the parts of the system that have to be replaced have actually been replaced)
Read_clutch_Gallardo.dra (reads the degree of clutch wear in e-gear cars
Read_write_clutch_Gallardo.dra (in e-gear cars, allows the initial clutch wear value to be written after the clutch has been replaced.)
Selflearning_egear_Gallardo (allows the e-gear system to be re-calibrated if the control unit or the entire system is replaced.)
Write_clutch_Gallardo.dra (in e-gear cars, allows the current clutch wear value to be written after the e-gear control unit has been replaced. The essential PIS have been inserted to improve car drivability)
Should i run them?
To replace clutch i ordered the following:
1 X 7L105269F CLUTCH/FLYWHEEL ASSEMBLY
1 X 86141671L CLUTCH RELEASE BEARING
1 X 7L105276 PILOT BEARING
1 X 86141297 CLUTCH POSITION SENSOR
1 X 7L103051A REAR MAIN SEAL
8 X WHT000938 MOUNTING SCREWS
3 X N10124306 MOUNTING SCREWS
1 X N90111302 O-RING
1 X WHT002218 O-RING
2 X TUTELA CS SPEED FLUID (LITER)