[LP640 Width at Outside of Rear Wheels.]

Outside to outside wheel is around 80, BUT this is the deal...

 

I have my old one lowered with very wide and aggressive wheels close to the fenders. It sat wider than a oem height and oem wheel murcie. 76.5” will not work, IF again, IF it has any outside rails where the tires would hit at 76.5”. If it can hang off the outside of the runways then it’s only 2” on each side or so and it’s ok.

 

Thanks, that is the information I was looking for. I just might be able to make it work if it's anything less than 80".

[LP640 Width at Outside of Rear Wheels.]

Can anyone with an LP640 please provide me an actual measurement from the outside of the left rear wheel to the outside of the right rear wheel? The only specifications I can find on the Internet are for the vehicle width (which is usually wider than width at rear wheels) and vehicle track (which is measured from the center of the rear wheels).

 

The reason I ask is because I need to know if it's going to fit on my 4-post lift. The width between the columns is 89 3/4". But, the drive through clearance of the lift (at the wheels) is only 76.5".

 

Any actual measurements I can get would be great. If on a standard Murci, that would be great too.

 

Thanks!