g9901920 Report post Posted October 13, 2009 Could anyone please tell me the diablo bolt pattern. specifically these wheels. Quote Share this post Link to post Share on other sites More sharing options...
ben Report post Posted October 13, 2009 up up down down left right left right b a b a start start (NES Gamers rejoice) Quote Share this post Link to post Share on other sites More sharing options...
Guest skokos Report post Posted October 13, 2009 LOL @ ben! That nintendo combo makes me nostalgia so hard haha. P.s new guy...writing your title in all caps won't get your thread anymore attention. Its just annoying. Quote Share this post Link to post Share on other sites More sharing options...
Kevin2772 Report post Posted October 13, 2009 up up down down left right left right b a b a start start (NES Gamers rejoice) Someone has been playing Contra!!!! And wasnt it select start? not start start?! Quote Share this post Link to post Share on other sites More sharing options...
Guest SP_LOTTA MURCI Report post Posted October 13, 2009 lol, i believe the answer to this is 5x120 Quote Share this post Link to post Share on other sites More sharing options...
azlambo Report post Posted October 13, 2009 up up down down left right left right b a b a start start (NES Gamers rejoice) I remember that! It gives you 30 guys instead of 3! Quote Share this post Link to post Share on other sites More sharing options...
g9901920 Report post Posted October 13, 2009 Thank you lotta murci for the answer. As for the the caps i will keep that in mind (As i am new-ish to forums). Thank you. Quote Share this post Link to post Share on other sites More sharing options...
topcabron Report post Posted October 13, 2009 I have no idea whats gong on here. Quote Share this post Link to post Share on other sites More sharing options...
Shamile Report post Posted October 14, 2009 Dear Lamborghinisti, OK...OK....I'll bite. Set your wheel on the hub with a single bolt hole at (6 o'clock) position. OZ racing sticker should be at 6 O'Clock position and upright read position. The air valve should be at 12) clock position. Set bull center cap with the "S" of the tail in the horizontal position. The left most hoof will angle slightly down but the bull will be level. Now to tighten. First hand screw all bolts in and finger tighten. Make sure wheel is fully backed on hub. Start at 6 O'Clock then upper bolt at 11 then 4, then 7, then 2. Tighten in small increments till hand resistance. Then with torque wrench tighten to final 75ftlbs . There you go ....one tall thin blonde in return please. Shamile Quote Share this post Link to post Share on other sites More sharing options...
sandstrs Report post Posted October 14, 2009 Another problem solved by the board. Quote Share this post Link to post Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.