jason McVicar

That was a deal! Esp if the buyer is in Canada. But the interior is one of the worst colour combos ever.

Shouldnt the hp and torque curves cross at 5252rpm??????

Billet throttle bodies??

did you just have the bumper off for exhaust install? if so the plug is undone.

Did u have the clutch replaced? if so it kind of looks like a clutch alignment tool.

Thank you Jeff!!! I had a #3 and #4 missfire code and the car was running poorly. I found loose cat thermocouples and I cleaned the missfiire tubes. Then i clean the bmc air filters and throttle bodies. Finally I changed all the plugs to the ngk S2000 plugs and she runs like a champ now!!!!

Quick question for you folks!! Which bank is number 1 and are the cylinders counted from the front of the car to the rear? Thanks. I tried a search but came up dry.

Thank you! exactly what i was looking for!!!

I'm looking for the factory alignment specs for my 06 G. I did a search and nobody seems to have them. Any help is appreciated!!

Welcome to Canada where gas costs $6:50 a gallon and wraps cost $17,000!!! Let me see 70 hours of labour at $60/hr = $4,200 so the material is $12,800?????

Take the unit to your local electronic parts house. They will probably have a replacement micro switch for small money. There is probably a part number on the switch itself. But a good electronics guy can find u a replacement switch.

I'm in vancouver and might be interested in your old front bumper. pm me a price. thanks, Jason.

Can anyone tell me what the 2.00h warning light in the center of the dash means?

Not an RX7 a Hayabusa!

Thanks. I will check and see if there is some debris on the abs ring and go from there.